[Notice]
- This product is intended for people over the age of 14 and is not intended for children.
- The color of the product may be slightly different from the actual color depending on the monitor specifications.
1. This product uses one CR 2032 battery, which is included. To prevent battery drain, remove the insulating film before use.
2. The battery can be replaced by opening the back of the watch.
3. The character in the upper right corner of the LCD that displays the time will remain on even without batteries.
4. If the product is damaged, stop using it.
5. To prevent product deformation and corrosion, store in a dry place without moisture, and do not expose to high or low temperatures.
6. Please be careful not to let children play with it as a toy.
7. Do not disassemble the product on your own.
8. Install the product in a stable location to prevent damage to the product or personal injury due to falling.
9. Keep away from the fire or heat. There is a risk of product explosion if brought into close proximity.
10. Use standard batteries that meet product specifications.
11. If liquid leaks from the battery, or soot or swelling occurs while using the product, stop using it immediately.
12. As the batteries drain, the screen may become blurry or the clock may run slowly. Please replace the batteries.
[How to set the time]
1. After separating the back side of the product, press the SET button for about 2 seconds to switch to the year setting mode.
2. Set the year first by using the + and - buttons and press the SET button again.
3. Set the “month” and press the SET button.
4. Set the “day” and press the SET button. (The day of the week is automatically set to the day of the corresponding year.)
5. Set 12 or 24 hours, press the SET button.
6. Set the “hour” and press the SET button.
7. After setting the “minute”, press the SET button to complete the setting.
* The home screen displays 00:00 on January 1, 2026.
* Setting order: Year → Month → Day → 12-hour or 24-hour → Hour → Minute
* In all setup steps, press the SET button after setting to move to the next step.
* The setup mode will automatically end, if no operation is performed for 30 seconds during the process.
* To reset the time, press and hold the SET button for about 2 seconds and proceed again.